Elektral ThruScan Manuel d'utilisateur télécharger pdf (Page 41)

7.2.2 SIDE PANEL PROTECTION COVER

The “protection cover” is designed to protect the side panels from drizzled rain. It is made of plastic

material.

7.3 BATTERY GROUP

ThruScan operates for approximately 2 hours with its standard inbuilt uninterrupted power

supply/UPS with batteries. It is possible to increase this duration upon demand optionally.

7.4 WTMD WHEELER

This device is designed as an accessory for the WTMD ThruScan

models

to ease their transportation. (See 10.4)

7.5 CARRIAGE BAG

Carriage Bag is an option to provide an easy transportation where WTMD Wheeler can not be used

for an unassembled WTMD. (i.e. for ships to be unpacked for assembling in ports for the security of

the passengers)

7.6 IRDA REMOTE CONTROL

(*only for ThruScan sX/s15-i/sX-i)

This unit enables to operate and manipulate WTMD in an adequate distance by

IRDA technology. Security personal can control the unit from a distance behind a bullet-

proof cabin under threat. (see 10.3)

7.7 REAL-TIME VISUAL PROSECUTION UNIT

This unit can be assembled on ThruScan

Walk-Through Metal Detectors (WTMD)

as an

optional external part. The Passage and around the WTMD can be continuously observed using a

TV. Alarmed Visitors and/or movements around the WTMD can be captured by Real-Time Visual

Prosecution Unit. Captured images are saved to an SD Card. (there is an SD card Slot on the upper

part of the control unit keypad)

Assembly and Operation guideline of the Real-Time Video Prosecution Unit is as follows;

Remove the Screw and Nut from the Camera installation bar. First insert the Camera Cable and the

assembly bar from the hole on the control unit. The bar is designed to fit into the fixing piece inside

the control unit. Use the Screw and the Nut to fix the Camera Assembly bar to the Control Unit.

Connect the camera socket to the same number connector inside the control unit.

If you wish to continuously observe images from the system using your TV, use the cable delivered

along with the Real-Time Video Prosecution Unit. The RJ11/12 socket should be connected to “TV”

Marked Connector on the Control Unit and connect the other end to your TV.

Settings are done by using the Remote Control Unit. To enter Programming Mode enter [8888]

access code. This Code is Standard and can not be changed. After entering the code, ‘CAMERA

MENU’ will be displayed on LCD and you may proceed the below settings.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 56 57

Pas de commentaire

Elektral ThruScan Manuel d'utilisateur Page 41