Elektral ThruScan Manuel d'utilisateur télécharger pdf (Page 20)

3.1.4 UPS INDICATOR

When the Mains Voltage is cut off the WTMD will continuously operate from the

Battery, the battery mode operation indication will be continuously active (yellow

LED); if the battery voltage drops under a certain level the Yellow LED indicator will

start flashing; and if the battery Voltage will no longer enable WTMD Operation, the

Yellow LED indication will be flashing Continuously, there will be an intermittent audio alarm tone

and then the WTMD will then automatically shuts itself.

3.1.5 IRDA REMOTE CONTROL RECEIVER

(*only for

ThruScan

sX/ s15-i/sX-i)

It is the receiving LED of the pilot Remote Control Unit.

3.1.6 TRAFFIC INDICATOR LEDS (LIGHTS)

The Traffic Light simulation on Side Panels and the Control Unit enables the Security

Staff to decide whether the WTMD is ready for detection and the passage is empty.

Green indicates “Walk”, Red indicates “Stop”.

3.2

TOUCHPADS

A total of five touchpad controls are located on the control unit as follows;

3.2.1 ON - OFF BUTTON

The ON-OFF touchpad button turns on and off the WTMD. At each start up a 10

second self test is being carried out ten seconds during which time a ‘test tone’ will be

heard. Please wait for 1 minute after switching on before using the gateway in order

to allow the auto-calibration program to designate/memorize for metal objects around

its environment.

You may Turn Off your WTMD by pressing 2 seconds to ON-OFF button and release. The previous

settings and adjustments would be stored when you turn off your WTMD and will be displayed

when on again.

3.2.2 RUN(X) BUTTON

The RUN(X) touchpad button returns the WTMD to RUN(X)/operation mode after

any programming changes are made using the SEL(√) button. It is also used as an

“ESC” button when no changes are made.

3.2.3 SEL(√) BUTTON

The SEL(ect) touchpad button is for to access and enter the programming modes

and to confirm programming changes. It serves as an “ESC” button.

3.2.4 UP&DOWN BUTTONS

The UP&DOWN touchpad buttons moves up and down through the

programming options when on the MENU thus the programming mode. These

buttons is called UP&DOWN Buttons afterwards.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 56 57

Pas de commentaire

Elektral ThruScan Manuel d'utilisateur Page 20